Our technologies
Phosphating
A microcrystalline zincphosphate layer is created on steel parts in barrels or on racks. Additional oils can be applied on the phosphate layer that provide good temporary corrosion protection or serve...
Wet painting
Parts are painted by a robotic painting system with filtered and conditioned air supply. The system can apply primer and top coat in one cycle, using waterborne or solvent based, 1K-or 2K paints. Plastic...
Zinc-plating
Zinc-plating can be applied as a single-layer corrosion proctection or as primer of a duplex coating. Cr(VI)-free passivations are added after a single-layer application. ...
Zinc-nickel-plating
The zinc-nickel-alloy deposition line was realized within the ‘GVOP 1.1.3.’ project supported by the European Union. This is the most modern galvanizing technology in automotive industry,...
Powder painting
The powder painting technology is part of our duplex coating program that provides aufomotive quality. The line is equipped with the most modern PP booth and ultrasonic powder sieving unit. The...
Nanoceramic treatment
This procedure is mainly used for the finishing of aluminium parts. Titanium-zirconium nanocrystals are deposited on the surface that promote the adhesion of further layers - e.g. wet painting, powder...
Black finishing
The 1 μm thin black layer gives temporary corrosion protection and decorative appaereance at same time. ...
Shot-blasting
Shot blasting is carried out in a closed blasting cabinet with rubber belt. The parts are spun by the belt in front of the shot-blasting wheel, so the grit finishes the parts all around. Small, 0,3-0,4...
Vibration cleaning
Stamped or diecast parts are deburred and cleaned by abrasing compounds in the cleaning equipment.. ...